Compared to model F25, the F25 INOX press basket is made of stainless steel and can not be disassembled into two parts.
The press has a tilting frame
that provides convenient access to the basket for filling it with crushed
fruit. To tilt the frame it is necessary to unscrew its fastenings. After that
put a filter bag inside of the press basket and fill it with crushed fruit. The
filter bag will hold the crushed fruit inside of the basket and filters the
juice from the pulp. When filter bag is used while pressing, there is no need
to filter the juice afterwards. When the filter bag is filled, the edges of the
bag are turned on top of each other so that they overlap and do not let the
crushed mass to come out from the bag.
To start pressing, the frame
fastenings need to be tightened again. After that the press handles need to be
rotated until the press comes in contact with the filter bag inside of the
basket. The pressure of the press should be raised slowly with the handle of
the press rotated slowly and not immediately at full speed. Otherwise the juice
can not flow out from the pulp and the juice yield from the mass will be lower.
The groove below the basket of
the press is made of stainless steel and it collects all the juice that flows
out from the crushed fruit. It is necessary to place a collecting vessel or a
bucket underneath the groove, where the juice is collected in the end of the
pressing process.
We
recommend that you disassemble the press after the use and rinse it with water
from the hose.
_block.jpg)
_block.png)
_block.png)
_block.png)
_block.png)
_block.png)
